Original Japan GOOT Desoldering Wicks Braid Copper Wire Solder Remover BGA Wick RoHs Lead-free MSDS Welding Flux Tools | Инструменты

Original Japan GOOT Desoldering Wicks Braid Copper Wire Solder Remover BGA Wick RoHs Lead-free MSDS Welding Flux Tools | Инструменты

Original Japan GOOT Desoldering Wicks Braid Copper Wire Solder Remover BGA Solder Wick RoHs Lead-free MSDS Welding Flux Tools

Features:

FOR LEAD-FREE DESOLDERING Our thin and soft desoldering wire’s flat braid has efficient thermal transmission. Removes solder faster with better heat response than previous wicks. Recommended for lead-free solder with high heating load. Bargain extra-long wicks with spool. Makes it easy to take anywhere.

Instructions for use:

1.In desoldering, after the chips are taken down, the mainboard will leave a lot of solder, which will affect the chip welding. Usually cleaning the tin, the method is to put the iron tip on the suction tin wick, and then slowly move on the chip pads, and the solder will be sucked up with the suction tin wick. 2.After this, the best method is to clean the chips with washer water. Tin of big chip components can be cleaned with the suction tin wick. Tin of aluminum electrolytic capacitors can be cleaned with suction tin. 3.After each use, cut off the part of used, you can reuse.

Specification:

CP-15B; 1.5mm*30M CP-20B; 2.0mm*30M CP-25B; 2.5mm*20M CP-30B; 3.0mm*20M CP-35B; 3.5mm*15M