Upgraded Version of NanoVNA Antenna Network Analyzer Vector MF HF VHF 10Khz-1.5GKHZ(Mhz) |

Upgraded Version of NanoVNA Antenna Network Analyzer Vector MF HF VHF 10Khz-1.5GKHZ(Mhz) |

This is a DIY product that provides as perfect vector network measurement function as possible in the size of a credit card
Contains a 2.8-inch Press sn,650mAh battery,can be used offline for 2 hours
TX/RX mode measurement,can measure the complete S11 and S21 parameters,if you need to obtain S12 and S22,you need to manually replace the transceiver port wiring
Measure the short wave antenna,the yellow line is displayed on the sn as standing wave ratio: (Note: Since the machine uses SMA ports,the SMA ports are cast copper parts,please do not connect the hard 50-7/RG213 cables directly through the M to SMA connector SMA port,so as not to dae the SMA port,you can use the attached SMA cable to connect to the SMA port as shown in the figure below,and then use the M to SMA connector to connect)
Measuring frequency: 10KHz ~ 1.5GHz
RF output: 0dbm (±2dB,fundamental wave)
Frequency accuracy: Less than 2ppm
Frequency stability: Less than 0.5ppm
Measuring range: 70dB (50kHz-300 MHz),(50dB (300M-900MHz),40dB (900M-1500MHz));
Port SWR:Less than 1.1
Display: 2.8 inch TFT (320 x240)
USB interface: USB type-C communication mode: CDC (serial)
Power supply: USB 5V 120mA,built-in 650mAh battery ,
Number of calibration points: 101 (fixed)
Number of scanning points: 101 (fixed)
colour:black
material:Plastic + Metal

Package Contents:
1 * NanoVNA host
1 * USB data cable
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.